AiM logo
LCU-One Lambda Controller
Full control of your engine
LCU-One Lambda controller range of products allow
you to perfectly tune the carburetion of your engine
as well as keep it at its best, appreciably improving
your car performances.
All LCU-One lambda controllers use a wide band
Bosch LSU 4.9 probe either for its capacity
of saving the original calibration for its all life
and for its duration: Bosch LSU 4.9 probe,
in fact, has been designed to last for more
than 100,000 km on a stock car.
LCU-One's can detect punctual Lambda value from 0.65 to 1.6, offering you an extremely precise measurement, very useful for engine tuning.
Through the analysis of the remaining oxygen, LCU-One points out possible oxygen excess/lack in the carburetion, providing an essential information for 4 strokes engines: configurability of Stoichiometric ratio allows LCU-One to be used on petrol powered engines as well as on diesel or on alternative fuel (bio fuel, ethanol) powered ones.
Connection example
Three variants for all your needs
Uses a CAN bus and is extremely easy to install.
The product configures Stoichiometric point and provides:
Lambda value and Air/Fuel ratio
Lambda probe temperature and diagnosis
LCU-One Analog
Uses a serial line for programming and an analog output proportional to lambda value. To be even more user-friendly, LCU-One CAN and LCU-One Analog switch on/off together with the logger.
The product provides Lambda value and Air/Fuel ratio and - thanks to the dedicated Lambda Configurator software, LCU-One Analog allows to configure:
Stoichiometric point
Analog output (0-5 Volt)
LCU-One CAN + Analog
Is equipped with both CAN bus and analog output.
The product configures:
CAN connection+ Analog output
Stoichiometric point
LCU-One CAN + Analog also provides:
Lambda value and Air/Fuel ratio
Lambda probe temperature and diagnosis